SUITBASE® PRO | Assembly instructions

A video tutorial is in the final stages

packaging contents

1x SUITBASE® body
2x SUITBASE® hangers
1x SUITBASE® wall plate
2x countersunk screws with Phillips
4x lens head screws with hexagon socket
1x Allen key
4x Fischer® DUOPower universal anchors
4x SPAX® universal screws

Let's go

Step 1: Find the perfect place for your SUITBASE®.

Make sure that there are no electricity or water pipes running under the drilling points. Plan an area of ​​80 cm in width.
Tip: Simply hold your combo in the desired location.

Step 2: Assemble the SUITBASE®.

2.1: Take the body out of the packaging and hold it so that the side with the 4 threaded holes faces upwards. The side with the two threads faces towards the belly.

2.2: Take the lower bracket out of the packaging and place it with the holes over the two left threads. The easiest way to do this is to press the bracket against the body with your thumb. Now you can put two of the small screws into the holes and carefully tighten them with the long side of the key. Repeat the step with the other bracket on the right side.
Now insert the short side of the wrench into the screw head and tighten the screws carefully.

2.3: Now the wall plate is connected to the body using the two countersunk screws.

Step 3: Mount the SUITBASE® on the wall.

3.1: Get a pencil ready, hold the assembled SUITBASE® in the desired location and mark the drill holes.
Tip: The best angle is achieved when you place the bottom of the wall panel at eye level. This also ensures that the boots have enough space under the combo.

3.2: Now drill the four holes with a 6 mm drill and insert the supplied fischer® dowels with a hammer.

3.3: Fasten the SUITBASE® to the wall using the SPAX® screws. The easiest way to do this is to tighten the screws crosswise.

Step 4: Hang up your equipment and enjoy!

If you have any questions, you can contact us at any time via Instagram, email or by phone during support hours.
We can definitely help you!